I even followed the same steps again using the hidden system Administrator account thinking this may be some sort of permission problem. Works under Linux and Windows.Our standard USB IR Transceiver can send and receive infra-red (IR) signals. However, when I tried the next step of "flushing the updated configuration information to the registry" (step 2) There was no " IrDA network device" under Network Adapters in Device Manager. USB IR Transceiver 40.00 USB device to send and receive IR: have your computer send IR signals to your DVR receive IR signals from a remote control. ![]() I managed to follow the instructions as far as enabling Irda in an elevated command prompt and got the "./done" response for both commands. I have a lot of updates to install but am quite prepared to reinstall to go back to ver 1511 to get this to work. It so happened that I was having a lot of other problems relating to corruption of my installation of Windows (Ashampoo Burning studio was refusing to work properly and crashing) so decided to do a reinstall and follow the above article immediately afterwards. To cut a long story short I found this technical article which appeared to be the solution: Only recently I noticed that it had stopped working and so I started some research on the web to find the solution. ![]() I have an Infrared Remote originally designed to use with Windows 7 MCE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |